www.SurvivalIQ.com  
  Home  Survival Skills  Land Navigation  Survival Fitness email us 
Contents

1. Training strategy
2. Maps
3. Marginal information and symbols
4. Grids
  - Reference system
  - Geographic coordinates
  - Military grids
  - United states army military grid reference system
  - Locate a point using grid coordinates
  - Locate a point using the us army military grid reference system
  - Grid reference box
  - Other grid systems
  - Protection of map coordinates and locations
5. Scale and distance
6. Direction
7. Overlays
8. Aerial photographs
9. Navigation equipment and methods
10. Elevation and relief
11. Terrain association
12. Mounted land navigation
13. Navigation in different types of terrain
14. Unit sustainment

A. Field sketching
B. Map folding techniques
C. Units of measure and conversion factors
D. Joint operations graphics
E. Exportable training material
F. Orienteering
G. M2 compass
H. Additional aids
I. Foreign maps
J. Global positioning system
K. Precision lightweight global positioning system receiver

Survival Gear

Handheld GPS
Specialty Outdoor Gear
Digital Compasses
Survival Books
Hunting and Fishing Magazines

4-8. OTHER GRID SYSTEMS

The military grid reference system is not universally used. Soldiers must be prepared to interpret and use other grid systems, depending on the area of operations or the personnel the soldiers are operating with.

a.   British Grids. In a few areas of the world, British grids are still shown on military maps. However, the British grid systems are being phased out. Eventually all military mapping will be converted to the UTM grid.

b.   World Geographic Reference System (GEOREF). This system is a worldwide position reference system used primarily by the US Air Force. It may be used with any map or chart that has latitude and longitude printed on it. Instructions for using GEOREF data are printed in blue and are found in the margin of aeronautical charts (Figure 4-24). This system is based upon a division of the earth's surface into quadrangles of latitude and longitude having a systematic identification code. It is a method of expressing latitude and longitude in a form suitable for rapid reporting and plotting. Figure 4-24 illustrates a sample grid reference box using GEOREF. The GEOREF system uses an identification code that has three main divisions.

Figure 4-24.  Sample reference using GEOREF.

Figure 4-24. Sample reference using GEOREF.

(1)   First Division. There are 24 north-south (longitudinal) zones, each 15-degree wide. These zones, starting at 180 degrees and progressing eastward, are lettered A through Z (omitting I and O). The first letter of any GEOREF coordinate identifies the north-south zone in which the point is located. There are 12 east-west (latitudinal) bands, each 15-degree wide. These bands are lettered A through M (omitting I) northward from the south pole. The second letter of any GEOREF coordinate identifies the east-west band in which the point is located. The zones and bands divide the earth's surface into 288 quadrangles, each identified by two letters.

(2)   Second Division. Each 15-degree quadrangle is further divided into 225 quadrangles of 1 degree each (15 degrees by 15 degrees). This division is effected by dividing a basic 15-degree quadrangle into 15 north-south zones and 15 east-west bands. The north-south zones are lettered A through Q (omitting I and O) from west to east. The third letter of any GEOREF coordinate identifies the 1 degree north-south zone within a 15-degree quadrangle. The east-west bands are lettered A through Q (I and O omitted) from south to north. The fourth letter of a GEOREF coordinate identifies the 1 degree east-west band within a 15-degree quadrangle. Four letters identify any 1-degree quadrangle in the world.

(3)   Third Division. Each of the 1-degree quadrangles is divided into 3,600 one-minute quadrangles. These one-minute quadrangles are formed by dividing the 1-degree quadrangles into 60 one-minute north-south zones numbered 0 through 59 from west to east, and 60 east-west bands numbered 0 to 59 from south to north. To designate any one of the 3,600 one-minute quadrangles requires four letters and four numbers. The rule READ RIGHT AND UP is always followed. Numbers 1 through 9 are written as 01, 02, and so forth. Each of the 1-minute quadrangles may be further divided into 10 smaller divisions both north-south and east-west, permitting the identification of 0. 1-minute quadrangles. The GEOREF coordinate for any 0. 1-minute quadrangle consists of four letters and six numbers.



Grids
Reference system | Geographic coordinates | Military grids | United states army military grid reference system | Locate a point using grid coordinates | Locate a point using the us army military grid reference system | Grid reference box | Other grid systems | Protection of map coordinates and locations |




Buy The Book This Site Is Based On
The 'Land Navigation' section of this site is based on 'Map Reading and Land Navigation', a public domain work published by the U.S. Department of Defense that is available for sale at Amazon.com.




Copyright © 2008 SurvivalIQ.com. All Rights Reserved.

Disclaimers  |  Contact Us   |   Privacy